Top

Are You Spooking the Deer on Your Way to Your Stand?

December 2, 2007

By Shane Gulbrandsen
The answer to this is, of course you are. And if they are not spooked, they are aware of your presence.

All the pre-scouting and work to get your stand just perfect, might well be all for nothing. Have you ever been on your way to your stand and seen tails fleeing or heard deer snorting? Sure you have, we all have.

Now you get in your stand and your confidence and excitement level is not the same as when you started out. After sitting awhile without seeing a deer, you start to doubt your chances and abandon your stand. If this sounds familiar you’re not alone.

This is something all deer hunters face and no sure-fire solution. I have taken many hunters to a stand over the years, as well as gone to a few stands myself. I have learned some things about how to increase your odds of the deer not knowing you’re in your stand.

There are many products on the market that help hunters get deer to come within sight - scents, calls, camo you name it, it is all for the same goal. The problem is if the deer already know you are there, you’re in for a long day.

Let me tell you about this one occurrence I observed. This one stand I was in is at least a half a mile from any road. It is solid bush and no clearings and you could hear the traffic go by. I had been in the stand about a half-hour, when this 11-point buck appeared. He was slowly walking and feeding without a care in the world. He could hear the traffic as well and paid no attention to it.

Then for some reason, a vehicle that I could hear heading down the road, started slowing down and eventually stopped. Now remember this is a half-mile away from me with solid timber the whole way.

As the vehicle slowed to a stop, the buck lifted his head and totally froze. There was a big broadleaf plant in his mouth and he even stopped chewing. The vehicle eventually started off again and the farther it went the more relaxed the buck got.
The buck eventually fed his way out of sight.

Now you may think that this is nothing new or no big deal but all this took place with the buck only 20 yards from me. He never had a clue I was there. He showed more attention to a sound a half mile away from him, without any concern that I was above him.

Just imagine that vehicle that stopped out at the road was me and I was on my way to the stand that I was already sitting in. Would that buck be in the area by the time I got to the stand? Would I be able to lure him back out with calls? Of course not, he would already be wise to what was going on. Whitetail deer (especially bucks) are creatures of habit and routine.

The plan years ago to get to a stand was to use the four-wheeler the majority of the way, then walk the rest. Makes sense right? Wrong!

In 1995 an older gentleman from New York was hunting with me. Getting off the four-wheeler and starting our walk in the dark was starting to get too much for the hunter. One morning he asked me to take him right to the stand with the four-wheeler. I stated that this would spook the deer and to walk in quiet would be best.

He then stated that we were probably spooking them more by trying to walk in quiet. He said to take him right to the stand but do not turn off the four-wheeler or shine a light up to the stand to help him see to get in. Once he was in the stand and set up, I was then and only then to get out of there.

The old fellow killed a good buck at first light that morning. He told me that evening that as soon as I left him he was watching the lights of the four-wheeler weave its way back through the bush when two bucks started to spar about 100-yards from him.

Now those bucks were probably sparring while we were on our way in and saw and heard the four-wheeler coming. They simply stopped and watched the four-wheeler come and then go and resumed their match. As daylight approached they had no idea the hunter was in the stand.

The 11 pointer I had watched from the stand that listened to the traffic, I had someone bring me to the stand with the four-wheeler that day. Once I was in the stand, the four-wheeler left. Eventually it got back to the road and I could hear it being loaded into the truck. I heard all of that and so did the deer.

If you can get the deer in your area to get accustomed to hearing a four-wheeler coming in and going out, I would bet that you would see more deer. To the deer when they hear you coming in, they think trouble is arriving. When the four-wheeler leaves, they think trouble has gone. Do not shut the motor off though. Let the deer concentrate on the bike.

My trail camera pictures also prove this method works. I have pictures of deer looking in the direction that I always approach when I come to exchange the card in the camera. Then I get photos of deer right after I have gone.

Try it this fall for yourself. Early in the year, start riding into your stand, sit a few minutes with the motor running then leave. The deer will get accustomed to this activity and you can figure they have you patterned. Have a friend bring you in to your stand when season starts. Maybe you can return the favor to your friend. I hope this helps someone get the trophy buck of there dreams.

Shane Gulbrandsen
www.gulbrandsenoutfitters.com

Tree Stand Tips

December 2, 2007

By Robert Lane

Rpbert Lane - Master Maine GuideBob Lane is a Licensed Master Maine Guide and photographer. He has also guided Caribou Hunters and Fishermen on float trips in Southwest Alaska.

July’s warm, sunny weather doesn’t provide much incentive to think about deer hunting to outdoorsmen who are trolling for deep swimming salmon and togue, whipping out the fly line during the drake hatch, or pursuing numerous other activities in the Maine woods this time of year.

This time of year I find myself occupied with trying to decide where I’m going to fish during the week and on the weekends, and trying to fit the kayaking and photography in to boot. Being an avid outdoorsman is no easy task. With the expanded archery season opening in September, rifle season for the elusive whitetail opening in November, now is the time to begin preparation to increase your odds for a successful hunting season. Rifles need to be sighted in, bows and arrows need to be tuned, and shooting practice begun in earnest, and, if you hunt from a climbing tree stand, it needs to be inspected and readied for the upcoming days afield.

Over the last 10 seasons, I’ve shot nine deer from my portable climber and I swear by the method. I’d no more go out without it than I would without my favorite rifle. However, I find that the tree stand is the most overlooked piece of equipment in the hunter’s arsenal. Its usually hung in the garage, or tucked away in the cellar and forgotten about until a few days before the season opens. That’s no time to discover a problem that may require a repair or replacement part. Now is the time get it ready for archery and rifle season.

First and foremost is to go over the stand and check the welds. Make sure that they are still solid. I had a crack in one on a stand a few years ago. Luckily I caught it before I went out. It was a simple matter to get it repaired.

If your stand attaches to the tree by cables, check these carefully for fraying and general wear. Any doubt about their integrity is reason enough to replace both of them. If one is bad, most likely the other one will be too. Most manufacturers sell these and a variety of replacement parts for their climbing and stationary stands.

If yours is an older climber and made of steel, attach it to a tree and get in it. Stand up, sit down, twist, and turn and listen for any creaking noises, squeaks etc. Nothing will alert a deer to your presence more than a noisy stand. I lost a shot at a nice buck years back because of it. This is critical if you are a bow hunter and are shooting at close range. The deer that busted me was almost 40 yards away when my stand creaked.

Summit Tree StandNoise isn’t such a problem with the new aluminum models. I have one of these, but I still get in it just to be sure. I have found that birch trees combined with a climbing stand will make noise even after the stand has been secured in place. Most noise can be cured by tightening a loose part and making sure that it is snug against the tree when reach the desired height.

On steel stands rust can be a factor. It gives off odor that an animal can detect. Ask any fox or coyote trapper about rust. They dye and wax their traps to keep them from oxidizing and emitting a smell. Just because you’re 15 feet off the ground doesn’t mean scent from you and your equipment will go undetected by a deer. A number of variables such as temperature, wind, air density will affect how scent is carried to the nose of a wary whitetail. Any rust should be removed with a wire brush and the area repainted to prevent further rusting during the season when the stand is exposed to the elements. Doing so will also increase the life of the stand.

Once I’m up in my stand I stay all day, and that requires that I be comfortable. Cushions will wear out and the covering will deteriorate over time making them uncomfortable, or unusable. Sitting over a prime trail or feeding area is no place to be moving around in a tree stand trying to get comfortable. Check those seats early in the season and if they aren’t up to the job, repair or replace them. Again most manufacturers carry these and other replacement parts.

I always go over my safety harness at the end of each season and again in the summer, and check for fraying and other wear. Most harnesses have a special tacking on the tether strap that connects from the back of the harness to the tree, and is designed to lessen the shock of a fall. Most of these are designed to be used only once. Check yours to be sure this tacking is still intact. If it isn’t, consult the manufacturer before you use it.

I keep two four point harnesses in my truck at all times in case one becomes unserviceable. If you forget yours, either go back home and get it, or hunt from the ground. The records of injuries incurred as a result of falls from trees stands are grim. Many a hunter has been crippled for life and others have been killed from falls from as low as ten feet up.
Under no circumstances should you use anything but a four point harness when hunting from a tree stand. The old type that consisted of a belt around the waste could cause a hunter to hang doubled at the waist, or inflict serious internal injuries. Last year I saw a guy in a stand with a hank of tow rope under his shoulders attached to the tree by two half-hitches with about two feet of slack in the tether rope. It was a recipe for disaster if I ever saw one.

My harness is on and attached to the tree as soon as I’m in the stand, and before I start climbing, as the majority of falls occur when ascending and descending the tree. Once I’m up in position I take all of the slack out of the tether. This pretty much eliminates any shock when the harness fetches up should I fall. The shock of a two hundred pound body falling a foot or even six inches and then being suddenly fetched up is painful at best and could result in injury. No slack in my tether also allows me to use it as a stabilizer and lean out over the stand when bow hunting.

Always carry a cell phone and let someone know where you are and when you expect to be out of the woods when hunting from a tree stand. I have several emergency numbers pre-programmed into mine. My phone has a lanyard on it that is looped through the buttonhole in the flap of my shirt pocket, eliminating the possibility of dropping it. If you should have a mishap and are unable to climb back down the tree, the phone could mean the difference between a long stint and possibly an overnight hanging in your harness. Your chances of hanging up-right and being able to call someone on the cell phone are better if you are strapped into nothing less than a four-point safety harness. Over the last couple of years I’ve seen several devices on the market that are designed to assist hunters in getting back to the ground after they have fallen and are hanging in a safety harness. These can be found with a little searching on the web. Summit is a major manufacturer of tree stands, harnesses, and accessories. I’ve had good luck with their products. Check them out at www.summitstands.com

Tree stand inspections and proper safety procedures don’t take a lot of time or effort, or even cost much for that matter. They can save a day’s hunt or even a life. While not all falls are fatal, many, hunters have seen an abrupt end to their hunting days due to crippling injuries resulting from a fall from a tree stand that hasn’t been properly maintained, or used in conjunction with a safe, four-point harness.

When opening day rolls around, I want to be up in my favorite tree at daybreak, watching the shadows give way to the day, and listening to the sounds of the woods waking up. I’ll watch the edge growth, the hardwoods, and the thickets, confidently focusing on the hunt, knowing that my stand is secure and my harness safe, because I took the time to go over my gear well before the onset of the best season of the year.

Bottom